Surface Analysis Error

Forums Welcome to the support forum! Surface Analysis Error

This topic contains 1 reply, has 1 voice, and was last updated by  francesca.pagliaro 5 months, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1520

    francesca.pagliaro
    Participant

    Hi!
    I created a multi-zone model for thermal analysis in Grasshopper/Archsim. I checked the geometry with the Surface Analysis Component and the results were ok. After a while, I’ve noticed that the Surface Analysis Component results were changed and the component was reading horizontal surfaces as vertical and vice versa. I don’t understand if I’ve changed some settings or it is a bug.
    Any help is appreciated!

    Francesca

    #1521

    francesca.pagliaro
    Participant

    Problem solved. I changed the “roof tilt angle” and the “exterior floor tilt angle” in the Thermal Zone component settings. This is why Archsim inverts horizontal surfaces with vertical ones!

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.